Zpc 9820CH User Manual

Pg 1 of 14Before You BeginThank you for purchasing this prod-uct. We’ve included easy to followstep-by-step instructions which havebeen carefully writ

66Carefully place top assembly on bottomassembly. NOTE: Be sure to align cambolts(C) with holes in bottom side panels (6).Coloque cuidadosamente el en

Pg 11 of 14Fasten hinges (H) to doors (5). Asegure las bisagras (H) a las puertas (5). Fixez les charnières (H) aux portes (5).12.Insert 2 snap cams (

Attach door knobs (J) to doors (5). Asegure las perillas para puertas (J) a laspuertas (5).Fixez les boutons de portes (J) aux portes(5).14.Fasten hin

Pg 13 of 1416.15.55LApply 2 bumpers (P) to back of doors (5). Coloque 2 protectores (P) en la parte pos-terior de las puertas (5). Appliquez deux past

Pg 14 of 1417.Top of the unitParte superior de la unidad Haut du meubleOMNNot IncludedNo IncluidoNon incluseMounting Instructions:It is imperative tha

Pg 2 of 14(A) 28 Large Screws28 Tornillos grands28 vis longues(C) 2 Cambolts2 Pernos para levas2 boulons à cames(E) NailsClavos ClousTools NeededHer

(2) 2 Middle Shelves2 Repisas Medias2 étagères médianes(4) 3 Support Rails3 Rieles de Soporte3 traverses d'appui(7) 1 Cabinet Back Panel1 Respald

1.Fasten 2 support rails (4) to bottom sidepanels (6). This is the bottom assembly.Asegure 2 rieles de soporte (4) a los paneleslaterales inferiores (

Place the bottom assembly in desired loca-tion. Then install bottom support rail (4) withfinished edge facing up. NOTE: The bottomsupport rail (4) may

Pg 6 of 14Fasten the magnet (F) to top panel (1). Asegure el magneto (F) al panel superior(1). Fixez l'aimant (F) au panneau supérieur (1).3.14.

5.Attach the other top side panel (3) to the toppanel (1).Fije el otro panel lateral superior (3) al panelsuperior (1).Fixez l'autre panneau laté

Attach the bottom shelf (1) to the top sidepanels (3). NOTE: Make sure the side of thebottom shelf (1) with the most holes is facingaway from the top

Pg 9 of 14Lay unit face down on floor. Fasten backpanel (7) to back of unit. NOTE: Make surefinished side of back panel (7) is facingdown. This is the