Pg 1 of 14Assembly Instructions - Model 9119W (White)Instrucciones de Ensamblado - Modelo 9119W (Blanco)Instructions d'assemblage - Modèle 9119W
Pg 10 of 1466Dtop assemblyensamble superior Unité supérieureCarefully place top assembly on bottomassembly. NOTE: Be sure to align cambolts(D) with ho
Pg 11 of 14Insert hinge bushings (J) into middleshelves (2).Inserte los cojinetes para bisagras (J) en lasrepisas medias (2).Introduisez les rondelles
Pg 12 of 14Fasten a hinge (I) to the bottom of eachdoor (5). Asegure una bisagra (I) a la parte inferior decada puerta (5).Fixez une charnière (I) au
Pg 13 of 14Attach door knobs (L) to doors (5). Applystickers (R) to unused holes on each side ofunit. Apply screw caps (L) to large screws(A) on exter
Pg 14 of 1417.Top of the unitParte superior de la unidad Haut du meubleNot IncludedNo IncluidoNon incluseQOPMounting Instructions:It is imperative tha
Pg 2 of 14(A) 28 Large Screws28 Tornillos grands28 vis longues(D) 2 Cambolts2 Pernos para levas2 boulons à cames(C) 4 Dowels4 Clavijas 4 goujons(O) 1
(2) 2 Middle Shelves2 Repisas Medias2 étagères médianes(4) 4 Support Rails4 Rieles de Soporte4 traverses d'appui(7) 1 Cabinet Back Panel1 Respald
1.Fasten 2 support rails (4) to bottom sidepanels (6). This is the bottom assembly.Asegure 2 rieles de soporte (4) a los paneleslaterales inferiores (
Place the bottom assembly in desired loca-tion. Then install bottom support rail (4) withfinished edge facing up. NOTE: The bottomsupport rail (4) may
Pg 6 of 14Fasten the magnet (G) to the underside ofone of the middle shelves (2). Asegure el magneto (G) a la parte inferior deuna de las repisas medi
5.Gently tap in with a hammer 2 dowels (C)into each end of one of the support rails (4)until less than 3/8” (10mm) is left stickingout. Attach the sup
Attach 2 middle shelves (2) to the the topside panels (3). NOTE: Make sure the mag-net (G) is on the bottom of the top middleshelf (2) facing the fron
Pg 9 of 14Lay unit face down on floor. Fasten backpanel (7) to back of unit. NOTE: Make surefinished side of back panel (7) is facingdown. This is the
Comments to this Manuals